Filter
Top Products
DC Controller
1 Remove the Printer Covers.
2 Disconnect the motor connector from the motor (Figure 6-39, callout 1).
3 Disconnect the Solenoid connector from the DC Controller (Figure 6-22, callout 1).
4 Remove the back sheet metal plate and disconnect the PS202/PS204 connector
(Figure 6-29).
5 Remove the AC Cable cover and disconnect the AC Cable from the DC Controller
(Figures 6-13 and 6-14).
6 Tip the printer on its top, with the front facing you.
7 Remove the (4) screws (Figure 6-40, callout 1). One of the screws is a grounding
screw. The location of the grounding screw is marked by a “star” etched into the
bottom of the DC Controller.
Note
Make certain when you reinstall the DC Controller that the grounding screw with
the washer is replaced in the same location.
DC Controller Removal (1 of 3)
Figure 6-40
6 - 44 Removal and Replacement