Filter
Top Products
3-9
Operating the Library
Entering the Administration Menu Password
Library Operation
Entering the Administration Menu Password
A numeric password is required to access options beneath ADMIN* menu of the
library (see Figure 3-2 on page 3-8). A three-part default password of 000-000-000
is set at the factory. To change the password, see “Setting a New Administration
Menu Password” on page 3-10.
To enter the password:
1. Verify that the drive status displays. If it does not display, press
CANCEL until it
does.
2. Press
NEXT until ADMIN * displays, then press ENTER.
3. PSWD 000-000-000 displays, and the first set of zeros flashes.
Press
ENTER to accept this number (if no password has been set), or press NEXT
or
PREV until the correct number displays. Press ENTER.
4. The middle set of zeros flashes.
Press
ENTER to accept this number (if no password has been set), or press NEXT
or
PREV until the correct number displays. Press ENTER.
5. The last set of zeros flashes.
6. Press
ENTER to accept this number (if no password has been set), or press NEXT
or
PREV until the correct number displays.
7. Press
ENTER. INFO * displays.
To access options under the ADMIN * menu, press
PREV or NEXT until the desired
option displays, then press
ENTER.
1 2 → ADMIN * → CONFIG *