Filter
Top Products
3-41
Operating the Library
Troubleshooting
Library Operation
CAUTION Do not press the library power switch until all SCSI peripherals connected to host
are shut down. Pressing the power button when the SCSI system is active can cause
data loss and/or problems with the SCSI interface.
DO INVENTORY TEST displays
(initialize element status).
• Power cycle the library by pressing the power switch off and
then on again. (See the caution note at the end of this
table.)
• Run the INVENTORY CHECK test under the TEST * menu.
Cannot write to the tape. • Check the host file system access permissions.
• Check the write-protect tab on the cartridge to assure
write-enabled status.
• Check the application software.
Cannot read the tape. • Check the host file system access permissions.
• Verify that the correct tape type is used (See “Choosing
Tape Cartridges” on page 2-3.)
• Check the application software.
Problem What to do