Filter
Top Products
3-39
Operating the Library
Troubleshooting
Library Operation
DEVICE FAILED displays.
Hardware Error #61 (External SCSI
cables) is reported.
• Make sure that only one SCSI device type (single-ended OR
differential) exists on the SCSI bus.
• Verify that the library SCSI selector switch is set correctly
(either single-ended or differential).
• Verify that the mode switch termination is set correctly.
The library’s power failed while a
cartridge was in the drive and did not
return to the drive status indicators
("ready" state) after the power came
back on.
• Press the power switch off and then on again. (See the
caution note at the end of this table.)
• If the power-on test is unsuccessful, switch off the power.
Call a service representative for assistance.
No display messages appear. • Make sure the power cord is connected.
• Make sure the power switch is on.
• Power cycle the library. (See the caution note at the end of
this table.)
• If there is still no display, call a service representative for
assistance.
Problem What to do