HP (Hewlett-Packard) 7115w Computer Drive User Manual


 
3-24
Operating the Library
Cleaning the Library Tape Drives
selected is flashing.) If the storage slot location is correct, press ENTER. To
select a different storage slot location, press
NEXT until the correct storage
slot location displays, the press
ENTER.
6. ###### SLOT # displays (“######” is a barcode number or is blank if
barcodes are not being used, and the storage slot location number is flashing).
Press
ENTER to select the displayed storage slot location or press NEXT or PREV
to select a different storage slot location, then press
ENTER.
7. CLEAN DRIVE 1 displays and the “1” is flashing. Press
NEXT until the drive
number to clean displays, then press
ENTER.
To clean both drives, press
NEXT or PREV until CLEAN DRIVE ALL displays,
then press
ENTER.
NOTE If the drives are not empty, a DRIVE FULL message displays, and the drives must
be emptied before they can be cleaned.
If the slot location chosen in Step 4 did not contain a cleaning cartridge, NOT
CLEAN CART displays briefly, then CLEAN FAIL # displays. Press
CANCEL to
twice to return to the “ready” state. Check the bulk load magazines in the library to
locate the cleaning cartridge. If no cleaning cartridge is present, insert one into an
available slot.
In the event of a drive error, such as a serial communications failure, FAILED
displays and the CLEAN DRIVES * menu displays.
CLEANING DRV # displays (# is the number of the drive being cleaned). When
the drive has been cleaned, CLEANED DRV # displays briefly, then CLEAN
DRIVES * is again displayed.
8. Press
CANCEL until the next operation to perform displays, or until the drive
status indicators (library “ready” state) are displayed.