Filter
Top Products
21
Step 7: Secure the drive
Note The server latches and side views of your server model may not be exactly the same as shown
in the illustrations. Please refer also to you server documentation.
Mounting hardware used (HP ProLiant)
Ensure that you use the correct mounting rails or locating screws, as described in “Step 4:
Attach mounting hardware” on page 15. The server also incorporates a locking mechanism
to hold the tape drive in place.
1 Push the server latch down to lock the tape drive into position, as shown in Figure 8a.
2 Replace the cover on the server.
No mounting hardware used (HP AlphaServer)
1 Use the M3 screws provided with the tape drive to secure it in place. Check that the holes in
the chassis are aligned with the holes in the sides of the drive and use a regular Phillips
screwdriver to secure the M3 screws, as shown in Figure 8b.
2 Replace the cover on the server.
ult960_master_internal.fm Page 21 Tuesday, September 21, 2004 4:13 PM