Filter
Top Products
Figure 3-5 Rolling the Unit Down the Ramp
Figure 3-6 Rolling the Unit to the Installation Location
8. Plug the unit into a power source.
3.2 Installing and Starting Up the Hardware
Familiarize yourself with the back of the c3000 enclosure and identify the OA interface port and
the HP GbE2c Ethernet switch. See Figure 1-3 (page 12). Verify that there is a blade in bay 1. See
Figure 1-2 (page 12) to identify bay numbers. For information about how to move blades in the
enclosure, see the HP BladeSystem c3000 Tower Enclosure Setup and Installation Guide .
http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c01310294/c01310294.pdf
3.2.1 Setting IP Addresses
Before setting the IP addresses, verify that your c3000 is not connected to the corporate network.
Make sure you have downloaded the information recommended in Chapter 2 (page 13).
1. Connect a cable from the OA to the GbE2c switch port 23. See Figure 3-7 callout 4. (For the
exact location of the interconnect switch, see Figure 1-3 (page 12) Callout 2.)
3.2 Installing and Starting Up the Hardware 17