Filter
Top Products
>> VLAN 2 add 7
>> VLAN 2 add 8
>> VLAN 2 add 21
>> VLAN 2 add 23
>> VLAN 2 ena
6. Assuming that the switch ssh or telnet management interface address has been assigned
to IP interface if 1, add that to the VLAN with the following commands:
>> VLAN 2 /cfg/l3/if 1
>> IP Interface 1 # vlan 2
7. Enter / at the CLI prompt, apply, and save the configuration as follows:
>> apply
>> save
8. Confirm saving to FLASH [y/n]: y
TIP: Attach the external ethernet to port 22 of the GbE2c switch to connect to the external
network.
For more information on how to configure VLANs for creating separate network segments,
including how to use VLAN tagging for devices that use multiple VLANs, see the HP GbE2c
Ethernet Blade Switch for c-Class BladeSystem Application Guide at:
http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c00701973/c00701973.pdf
For more information on how to configure VLANs for XC Software, see Section 2.6.4 in the HP
XC System Software Hardware Preparation Guide.
40 XC Software Installation