Filter
Top Products
Disconnected
Cause: Several situations can cause this error message to appear.
• Your computer is not turned on.
• Your computer is not connected to the HP All-in-One.
• The software that came with the HP All-in-One was not installed correctly.
• The software that came with the HP All-in-One is installed, but it is not running.
Solution: Make sure your computer is turned on and is connected to the HP All-in-
One. Also make sure you installed the software that came with the HP All-in-One.
For more information, see:
•“
Communication problems over a USB connection” on page 169
•“
Network troubleshooting” on page 183
No scan options
Cause: The software that came with the HP All-in-One is not running, or has never
been installed.
Solution: Make sure the software is installed and running. For more information,
see the Setup Guide that came with the HP All-in-One.
Out of disk space
Cause: There is not enough available memory on your computer to perform the
task.
Solution: Close some applications and try the task again.
Memory card must be in slot
Cause: The feature you are trying to use is only available when there is a memory
card or storage device inserted in the HP All-in-One.
Solution: Make sure you fully insert a memory card into the appropriate slot on the
HP All-in-One or connect a storage device to the front USB port, and then try the task
again.
Card access error
Cause: There are two or more memory cards inserted into the HP All-in-One at the
same time.
Solution: Remove all but one memory card. The HP All-in-One reads the remaining
memory card and displays the first photo stored on the memory card.
Cause: You have inserted a Compact Flash memory card backwards or upside
down.
Errors 265
Troubleshooting