Filter
Top Products
• The HP D2D is supplied with an HP Smart Array P800 controller (with 512 MB and two
BBWCs) pre-installed in one of the full-height PCI-e slots. For more information about this card,
search on http://www.hp.com/support/manuals. Part numbers are as follows:
◦ P800 card: 398647–001
◦ 512 MB memory: 398645–001
◦ BBWC: 398648–001
• The system has an HP Dual Channel 4Gb PCIe Fibre Channel Host Bus Adapter, part number
AE312A
Figure 5 Rear view of the HP D2D4112 G1
5. PCI-e slots (two full and one low profile)1. Power supply cable sockets (two)
6. VGA port for system console monitor2. LAN port 1 (always used for data connection)
7. Ports for system console keyboard and mouse3. LAN port 2
4. Management LAN port (Do not use for data))
NOTE: One full PCIe slot has a SmartArray RAID controller card pre-installed. The other full PCIe
slot is used for the FC card. You must install the Tape Attach card (SAS or SCSI) in the low profile
slot.
Using the ProLiant Guide with HP D2D4004 and 4009 G1 models
When using the HP ProLiant DL185 G5 guide, be aware of the following HP D2D-specific
information:
• The system components are illustrated in the 12HDD server diagram. Two processors are
supported - Opteron 2222, part number 451810–001, and Opteron 2384, part number
495643-005. If you need to replace a processor, please refer to the document EH938-90942
Replacing processor in HP D2D400x, which can be found on the Manuals page of the HP
web site http://www.hp.com/support/manuals.
• The HP D2D has removable hard disks, either 6 or 12.
• There is no optical media storage.
• The configuration of the system memory is 8 GB (8 x 1 GB DIMMs). The part number for each
1 GB DIMM is 416356-001.
HP D2D and HP ProLiant 11