Filter
Top Products
Storage controller option
IMPORTANT: For additional installation and configuration information, refer to the
documentation that ships with the option.
To install the component:
1. Power down the server (on page 13).
2. Remove the server from the rack (on page 13).
3. Remove the access panel (on page 14).
4. Remove the PCI riser board assembly (on page 14).
5. Remove the hard drive cables.
6. Install the storage controller ("Expansion board option" on page 32).
7. Connect the storage controller cable to the controller and to the hard drive.
See the server installation sheet and the documentation that ships with the storage controller.
IMPORTANT: The server does not power up if the PCI riser board assembly is not seated
properly.
8. Install the PCI riser board assembly (on page 15).
9. Install the access panel.
10. Install the server into the rack.
SAS hard drive LED cable option
The SAS hard drive LED cable provides LED functionality for SAS hard drives when an optional SAS
controller and an optional SAS controller cable are installed.
To install the component:
1. Power down the server (on page 13).
2. Remove the server from the rack (on page 13).
3. Remove the access panel (on page 14).
4. Install the optional SAS controller ("Expansion board option" on page 32).
Hardware options installation 35