Filter
Top Products
Description Spare part number
In Sonoma red finish 641480-001
In steel gray finish 650798-001
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 59), and then remove the following components:
●
Optical drive (see
Optical drive on page 60)
●
Hard drive (see
Hard drive on page 62)
●
WLAN module (see
WLAN module on page 67)
●
Keyboard (see
Keyboard on page 70)
●
Top cover (see
Top cover on page 74)
●
System board (see
System board on page 85)
Remove the display assembly:
1.
Release the wireless antenna cables from the clips (1) and the opening in the base enclosure.
CAUTION: Support the display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other
computer components.
2.
Remove the six Phillips PM2.5×5.0 screws (2) that secure the display assembly to the computer.
NOTE: The left-most screw on the left hinge secures a display panel cable ground loop (3).
104 Chapter 4 Removal and replacement procedures