Filter
Top Products
7.
Remove the Phillips PM2.5×4.0 screw (1) and the two Phillips PM2.5×5.0 screws (2) that secure
the system board to the base enclosure.
8. Flex the left side of the base enclosure (1) outward to provide clearance for the audio
connectors (2) and the other connectors on the left side of the system board.
9. Lift the front edge of the system board (3) until it rests at an angle.
10. Remove the system board (4) by sliding it up and forward at an angle.
Reverse this procedure to install the system board.
Component replacement procedures
89