Filter
Top Products
Booting From Burst Flash Memory
7-8 Getting Started with ADSP-BF548 EZ-KIT Lite
Booting From Burst Flash Memory
The BMODE0—3 input pins of the processor select the location accessed by
the processor’s boot loader at reset. On the ADSP-BF548 EZ-KIT Lite,
rotary switch
SW1 (labelled DSP BOOT) sets the values of the BMODE0—3 pins.
SW1 position 1 (default) selects the burst flash memory. When SW1 is in
position 1, every processor reset, including power-on, causes the boot
loader to start processing the contents of flash memory as a boot stream.
Figure 7-3. Flash Programmer: Programming Dialog Box