Filter
Top Products
5-2 ENWW
The Power light is on and
the Resume light blinks.
The printer is out of paper.
z Load paper and then press the
(resume button).
The printer is in manual duplex mode. It
is waiting for the ink to dry so the pages
can be flipped over and reloaded.
z Reload the stack into the printer and
press the (resume button).
The printer is pausing for the ink to dry.
z Wait for the ink to dry. The Resume
light will stop blinking.
The printer has printed a banner, and the
banner needs to be removed from the
printer.
z Press the (resume button) to
remove the banner from the printer.
The auto-duplex unit is not installed. The
printer cannot print without it installed.
z Install the auto-duplex unit, and then
press the (resume button).
The Power light and
Resume light blink.
Print media is jammed in the printer.
z Press the (resume button) to
eject the jammed media.
z Remove all media from the output
tray. Open the top cover to locate the
jam. After clearing the jam, press the
(resume button) to continue the
print job.
The Power light blinks and
the Resume light is on.
One or more covers on the printer are
open.
z Close any open covers.
z Make sure the auto-duplex unit is
properly installed.
A printer error has occurred.
z Turn the printer off and then on
again.
The Power light blinks and
the Printhead and Resume
light are on.
The printhead latch is not secured.
z Open the printing supplies cover and
secure the printhead latch.
The Printhead light, a color
indicator light, and the
Resume light are on.
One or more of the printheads needs
attention.
z Reinstall the printheads and try to
print.
z Try cleaning the printhead contacts.
See “Cleaning the printhead
contacts”.
z If the error persists, replace the
printhead or printheads indicated.
Light pattern Light description Explanation and recommended
action