Filter
Top Products
Modifying the FC domain ID (optional)
If desired, you can modify the FC domain ID. The d efault FC domain ID is domain 1. If
the 4Gb SAN Switch is not powered on until after it is connected to the fabric and the
default FC dom
ain ID is already in use, the domain ID for the new switch is automatically
reset to a unique value. If the switch is connected to the fabric after is has been p owered
on and the default domain ID is already in use, the fabric segments.
Type fabricsh
ow to determine the domain IDs that are currently in use. The maximum
number of domains with which the 4Gb SAN Switch communicates is determined by
this switch’s fabric license.
To modify the
domain ID:
1. Type switchdisable to disable the switch.
2. Type configure, then type a new value.
Or press Ent
er to accept each default value.
3. At the Fabric parameters prompt, type Y and press Enter:
Fabric parameters (yes, y, no, n): [no] y
4. Enter a unique domain ID. For example:
Domain: (1..239) [1] 3
5. Complete
the remaining prompts or press Ctrl+D to accept the remaining default
settings.
6. Type switchenable to re-enable the switch.
7. Type fab
ricshow to confirm any changes made to the domain ID.
8. Optiona
lly, verify switch policy settings and specify any custom status policies that
need to change:
a. Type switchstatuspolicyshow to verify the current policy settings. If
desire
d, type switchstatuspolicyset at the prompt to change switch
policy settings. This command sets the policy parameters that determine the
overall switch status.
b. Custo
mize the status policies as desired.
9. To deactivate the alarm for a particular condition, enter 0 at the prompt for that
condition.
Brocade 4Gb SAN Switch for HP c-Class BladeSystem
35