Filter
Top Products
Table 9 Connecting via a management station
Management
station
First switch Second switch Third switch
Ethernet
192.168.1.09 192.168.1.10
204.1.1.11 204.1.1.12
FCIP 192.168.65.09 192.168.65.10 192 .168.65.11 192 .168.65.12
G a t e way 19 2.16 8 .1.10
any, not self
192.168.1.10 192.168.1.10
Maintaining the
4Gb SAN Switch
The4GbSANSwitchdoesnotrequireanyregularphysicalmaintenance.
However, it is critical that environmental conditions, described in Environmental
requirements a
re met to help prevent switch failure due to heat stress or improper air flow .
Installing dust covers in empty ports
The dust covers included in the 4GB SAN Switch shipping carton, (see Figure 1) must
be inserted in ports where SFPs are not installed. Installing dust covers ensures proper
airflow and helps reduce dust contamination of the switch.
Replacing an SFP transceiver
In some case
s you might need to reinstall an SFP transceiver.
T o remove an SFP transceiver:
1. Press and hold the cable release.
2. Remove the
cable from the transceiver.
3. Pull the bail (wire handle) to release the transceiver.
4. Grasp the bail, and gently but firmly pull the transceiver out of the port.
5. Repeat this proced ure for the remaining ports as required.
Brocade 4Gb SAN Switch for HP c-Class BladeSystem
43