Filter
Top Products
+%!! 61
You need to become a
registered user to use this
digital sender. Please contact
your admin.
Allow user self-registration in
the General configuration
menu is disabled.
●
The administrator must add the user. See “Creating
and maintaining user profiles” on page 4 2.
●
Enable Allow user self-registration.
Control panel messages (continued
Message Description Actions
Internal error message descriptions and action
Code Description Actions
NOTE
Every internal error message has a code associated with it. Use the code to locate the
description and action.
5,xxxxx Internal software or hardwar
problem
●
Turn the digital sender off and then back on.
●
Verify control panel access hatch is snapped into place.
●
Verify all cables are seated securely.
●
If the problem persists, note the code and contact HPcustomer
support.
7,xxxxx Internal failure.
●
Turn the digital sender off and then back on.
●
Reconfigure all network parameters.
●
If the problem persists, note the code and contact HP customer
support.
10,0 Failure initializing address books.
●
Turn the digital sender off and then back on.
●
Check the address book database (see “Checking the address
book database” on page 39).
●
Clear the address book.
●
Reset the digital sender to factory defaults (see “Resetting to
factory defaults” on page 3 8).
NOTE: This also erases the administrator password, all TCP/IP
configuration, and all public and personal address books.
●
If the problem persists, note the code and contact HP customer
support.