Filter
Top Products
Icon Button name Description
1
Copy By default, print the number of copies currently configured in
HP Document Copy.
Alternatively, start the scanning software that is assigned to
this button.
2
Scan By default, start a scan that uses the HP Smart Document
Scan Software profile that is assigned to this button.
Alternatively, start the scanning software that is assigned to
this button.
3
Cancel Cancel a scan or copy in progress.
4
Tools Open the HP Scanner Tools Utility where you can do the
following tasks:
•
Associate the scanner quick start buttons with
scanning software
•
Configure the buttons on the scanner front panel
•
Manage the imprinter
•
View information about scanner settings, status, and
maintenance
5
Attention LED The Attention LED provides status information about the
scanner.
6
Power Save Press the Power Save button to put the scanner in Power
Save mode when you are not using the scanner. When you
are ready to begin scanning again, press the Power Save
button to wake up the scanner.
See also
•
Scanner LEDs
Scanner lamp setting
The scanner supports two modes of lamp operation:
• In Power Save mode, the scanner lamp times out and turns off automatically after about 15 minutes of
inactivity. When you are ready to begin scanning again, press the Power Save button to wake up the
scanner.
• In Instant Lamp On mode, the scanner lamp times out and turns off automatically after about 15 minutes of
inactivity, but it remains warm and ready to scan.
To switch from Power Save mode to Instant Lamp On mode, select the Enable Instant Lamp On check box on
the Buttons tab of the HP Scanner Tools Utility. To switch back to Power Save mode, clear the Enable Instant
Lamp On check box.
Chapter 1
4 Use the scanner