Filter
Top Products
70
Small Parts
(End User Replaceable)
The following small parts are all end user replaceable. The procedures are the same for the
OmniBook 2000, 5500, and 5700, except where noted.
Expansion Door - F1125-60920
Open the door and flex the center of the door until the side-tabs are released. Reverse to
replace.
Display Contrast/Brightness Slider Button - F1371-60917
Use a blunt probe to gently pry the slider button from the display. To replace, align the button’s
prongs over the contrast/brightness post and press firmly into place.
Door, Flash BIOS - F1371-60901
On the OmniBook 2000, remove the screw securing the door and lift the door off the bottom
case. Replace the door and screw. The OmniBook 5700 will have this feature added at a
later date; the OmniBook 5500 will not.
Hard Drive Security Cover - F1320-40001
Use a small phillips screwdriver to remove the hard drive screw and security cover. Reverse to
replace.
I/O Door - F1350-60910 (OB2000 & OB5700), F1320-60928 (OB5500 only)
Open the door and flex the center of the door until the side-tabs are released. Reverse to
replace.
Memory Cover - F1320-60927
Use a flat-blade prying device or fingernail to pry the memory cover off. To replace, snap the
cover into position.
PCMCIA Button Assembly - F1320-60949
“Unfold” the button, grasp firmly, and pull free. Reverse to replace.
Plastic Feet - F1320-60929
Flip the foot into an “open” position. Twist the foot to remove. Reverse to replace.
Printer Port Door - F1125-60918
Open the door and flex the center of the door until the side-tabs are released. Reverse to
replace.
Rubber Feet - F1320-60957
Place a probe or similar device between the rubber foot and the plastic of the bottom case. Pry
upward to pop the foot out. To replace, firmly press the foot into the hole.
Trackpoint Cap - F1320-60971
Grasp the cap firmly and pull upward. Reserve to replace.