Filter
Top Products
HP OmniBook 6000 Removal and Replacement 2-7
Removing the Hard Disk Drive
(User-Replaceable)
Table 2-5. Hard Disk Drive Replacement Part Numbers
Description Part Number Exchange Part Number
Drive, hard disk (5 GB, 9.5 mm, Hitachi) 0950-3825 F2072-69103
Drive, hard disk (6 GB, 9.5 mm, Hitachi) 0950-3732 F1660-69108
Drive, hard disk (6 GB, 9.5 mm, IBM) 0950-3710 F1711-69106
Drive, hard disk (10 GB, 9.5 mm, IBM) 0950-3831 F2072-69104
Drive, hard disk (12 GB, 9.5 mm, Hitachi) 0950-3733 F1660-69107
Drive, hard disk (18 GB, 12.7 mm, IBM) 0950-3712 F1660-69106
Required Equipment
• Small Phillips screwdriver.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery. Remove the secondary battery if one is
installed.
2. Turn the unit bottom side up and remove both hard drive screws.
3. Raise the cover on the end of the drive so that its retainer tab is free of the computer casing, then
gently pull the hard drive out of the computer.
Figure 2-6. Removing the Hard Disk Drive
4. Remove all six screws from the holder and drive case, then lift the drive out of the holder.
5. Notice that the hard drive has a pin connector attachment at one end. Carefully remove this
connector from the end of the drive. Work alternately at each end so that the connector slides off
evenly without bending the connector pins.
Screws, M2.5×4mm (2)