Filter
Top Products
Starting Out with Your OmniBook
Special Features
1-27
If your new hard drive has screws in different positions from the old one, you
will also need to adjust the insulator sheet. Compare the location of the screw-
holes in the new hard drive with those in the insulator sheet. If there is no screw
at position A, then unfold the flap at position A, and lay it flat before laying the
hard drive down on the insulator.
7. Holding the new hard drive by its edges, lay it in place. Grasp the right flap of
the insulator and pull to the left to engage the connection between the hard
drive and the computer. Do not push down on the hard drive. If the hard drive's
connectors do not engage the computer's connectors, pull the hard drive back
out and try again. Then fold the insulator sheet back over the hard drive.
A