Filter
Top Products
HP Omnibook XT6050, XT/VT6200 Removal and Replacement 2-19
Removing the Display Assembly
(HP Authorized Service Providers Only)
Required Equipment
•
Small Phillips screwdriver.
Removal Procedure
1.
Unplug the AC adapter, if present, and remove the battery and any secondary battery module.
2.
Remove the power button panel (page 2-11).
3.
Remove all four retaining screws from the back of the computer (two near the PS/2 port, and two
near the AC adapter jack).
4.
On the bottom of the notebook, remove the two screws from the rear corners (nearest the back
edge).
5.
Open the display. Remove the screws from the display ground wires, and disconnect the main
cable.
6.
Remove the screw from the center hinge cover, and from the left and right hinges.
7.
Lift the display off of the notebook.