Filter
Top Products
21
STACK menu settings
● The Main and Sub projectors have the following common settings.
- AV MUTE (
Operating Guide → Temporarily turning off the screen and audio)
- Magnifying feature (
Operating Guide → Using the magnify feature)
- ASPECT and OVER SCAN (
Operating Guide → IMAGE menu)
- COMPUTER IN (
Operating Guide → INPUT menu)
- MESSEAGE (
Operating Guide → SCREEN menu)
- MY BUTTON (
Operating Guide → OPTION menu)
- TEMPLATE (
Operating Guide → SCREEN menu)
- Lens shade (
Operating Guide → Temporarily shading the screen)
- SHADE TIMER (
Operating Guide → OPTION menu)
- SOURCE SKIP (
Operating Guide → OPTION menu)
- PbyP (
Operating Guide → PbyP)
<Only for CP-WU8440 and CP-WU8450>
● The following functions are disabled.
- Executing of AUTO KEYSTONE (
Operating
Guide → SETUP menu)
- STANDBY MODE (
Operating Guide → SETUP
menu)
- AUTO SEARCH (
Operating Guide → OPTION menu)
- Turning on/off AUTO KEYSTONE (
Operating Guide →
OPTION menu)
- DIRECT POWER ON (
Operating Guide → OPTION menu)
- AUTO POWER OFF (
Operating Guide → OPTION menu)
- COMMUNICATION TYPE (
Operating Guide → OPTION menu → SERVICE
→ COMMUNICATION)
● The input source from the following ports cannot be selected.
- USB TYPE A, USB TYPE B, LAN
● <Only for CP-WU8440 and CP-WU8450>
When the projectors are in the PbyP mode, SUB INPUT SOURCE is xed to
FOLLOW MAIN UNIT.
● When Intellectual Stack is in use, an error message will be displayed if an error
occurs on any of the projectors.
When an error occurs, a full dialog will be displayed on screen. The full dialog
changes to a small dialog after about 20 seconds without any key activity. While
the small dialog is displayed, pressing the ◄ button displays a full dialog again.
The numbers “1” and “2” above the projector icons represent the Main and Sub
projectors respectively.
Refer to the on-screen messages as shown below and take the necessary
actions to resolve the problem.
(continued on next page)
3.7 Important information for Intellectual Stack (continued)
Full dialog
Small dialog