Hitachi CP-SX8350 Projector User Manual


 
6
Installation
NOTE
• Set the tilt angle of Set A to within 9 degrees from the level line.
(continued on next page)
Deciding installation position
Decide the position of Set A and its projection angle. (User’s Manual (concise)
Arrangement and Adjusting the projector’s elevator)
2.2 Installing the rst projector (Set A)
Setting up Set A
2. Perform the INSTALLATION setting rst if necessary as it may change the
image position. (Operating GuideSETUP menu )
3. Adjust the image of Set A to t the screen with the ZOOM, FOCUS and LENS
SHIFT features. (Operating GuideAdjusting the lens)
Adjust the image position using KEYSTONE and PERFECT FIT if necessary.
(Operating GuideEASY MENU or SETUP menu)
NOTE • KEYSTONE cannot be operated when PERFECT FIT is in use.
To adjust the image using both KEYSTONE and PERFECT FIT, adjust
KEYSTONE rst.
• If you are using Simple Stack, go to 2.3 Installation of the second projector
(Set B). (
8
)
1. Turn on Set A.
WARNING
Only for CP-X8160, CP-WX8255 and CP-WU8450, it is possible
to install the projector for any direction with specied mounting accessories.
Consult with your dealer about such a special installation.