Filter
Top Products
5-9
3. When the Message “The Staple Cartridge is empty.” Appears
Chapter 5
When a Message Appears
Pull the staple sheet about 3 cm out of the
new Staple Cartridge and break off that
portion.
NOTE
Check that no portion of the staple sheet hangs
out of the cartridge. Break off any portion of the
sheet that hangs out of the cartridge.
Insert the new Staple Cartridge until it clicks
into position.
Push the Staple Unit back in and close the
Finisher Front Door.
Slide the Finisher back against the copier.
Touch and the copier
automatically feeds a sheet of paper to test
the stapling.
Remove the sheet of paper to check that it
has been properly stapled.
* If no staples are evident, repeat the procedure
from the beginning.
NOTES
• Replace the Staple Cartridge only after you
are prompted to do that by the message.
Removing the Staple Cartridge before then
will result in stapling trouble.
• After a new Staple Cartridge has been
installed, be sure to run a test-stapling
sequence to ensure that staples are properly
driven into the paper.
5
1136O012AA
1134O076AA
6
1155O070AA
7
1155O071AA
8
1155O072AA
9
Staple
1155O633CA
10
1155O644AC