Filter
Top Products
2-20
7. Auxiliary Functions
Chapter 2
Getting to Know Your Copier
The Interrupt function allows you to interrupt a
current job and run a different one. Pressing the
Interrupt key once sets the copier into the Interrupt
mode. Pressing the key again lets the copier leave
the Interrupt mode, returning to the previous
settings.
NOTE
To cancel an Interrupt cycle, you need to press
the Interrupt key. The Panel Reset key or Auto
Panel Reset function does not serve this
purpose.
Useful Tips
• Pressing the Interrupt key sets the copier into
the initial mode, except for the finishing
function which is Non-Sort.
• Custom Zoom and X/Y Zoom cannot be set in
the Interrupt mode. Cover, Page Insertion,
OHP Interleaving and Job Recall cannot be
set in the Interrupt mode, either.
By pressing the Mode Check key on the control
panel, you can either check for or change the
current settings.
• When you touch after having checked
the currently set functions, the Basic screen
reappears.
• To change a certain function, touch the
corresponding key and then make the necessary
change.
If an access number has been programmed, it
allows only particular persons to use the copier or
a supervisor to keep track of the number of copies
made by a particular department.
NOTES
• If an access number has been programmed, a
copy cycle can be initiated only after the
access number has been input to the copier.
<“Access #” Prompt Screen>
• Before you can use this function, you must
first turn “ON” the “Copy Track” function of
the Administrator Mode available from User's
Choice. ☞p. 4-19
Entering the Access Number
From the 10-Key Pad, enter the 4-digit
access number and press the Access Mode
key.
NOTE
To correct the 4-digit access number entered,
first press the key, then enter the new
number.
When the initial screen reappears, you can
now start the copy cycle.
When the copy cycle is completed, press the
Access Mode key again.
Interrupt
Mode Check
1155O227CB
Exit
Access Number
1155O398CA
1
123
456
789
0C
1134P438DA
C
2
3