Filter
Top Products
1 - 7
Multiple Image Scanner Operation
To put the image scanner in multiple image scanner mode, scan the bar code
below. Once you scan this bar code, the image scanner is unlinked from the
base and must be placed into the base to re-link.
Note: Multiple Image Scanner Operation Mode allows you to link up to 7 image
scanners to one base. You cannot join an eighth image scanner until you
unlink one of the 7 image scanners or take an image scanner out of
range.
Image Scanner Name
You are able to assign a name to each image scanner you are using. It will be
helpful to name the image scanners if you have multiple image scanners linked
to one base so that you will be able to control the image scanner receiving
imaging commands sent from the base. The default name for a 3820, for exam-
ple, is “3820”. If you have more than one 3820s linked to a base, the first image
scanner that is linked to the base receives commands addressed using this
name.
Changing Image Scanner Name - Serially
If you wish to change the name, you may change it via a serial command (refer
to "Menu Command Syntax" on page 10-1) or via a bar code command. To
change the name serially, unlink all except one of the 3820/3820i devices from
the base. Send “:3820:BT_NAM
name
.”, where
name
is the new image scanner
name. If you wish to change the name of additional 3820/3820i devices, re-link
them one at a time and repeat the “:3820:BT_NAM
name
.”
command for each
image scanner.
Multiple Image Scanner Operation