Filter
Top Products
1 - 8
Changing Image Scanner Name - via Bar codes
If you wanted to set up your image scanners with names 0001-0007, you may
scan the bar codes below.
Scan the Reset bar code after each name change
and wait for the image scanner to re-link to the base before scanning the next
bar code to name the next image scanner.
Alternatively, you may change the name with a bar code command if you cannot
send serial commands to the base. One way to do this is to scan the bar code
below and scan a number for the image scanner name. For example, if you had
7 image scanners to one base, scan the bar code below with the first image
scanner, scan the 1 bar code on the Programming Chart inside the back cover
of this manual and scan Save. Then scan the Reset bar code and wait for the
image scanner to re-link to the base before scanning the next bar code. Repeat
that process for image scanner number 2, 3, 4 etc.
If you want to assign an alphabetic name to the image scanner, create a Code
128 bar code containing “~BT_NAM
name
.” followed by a FNC3 character (hexi-
decimal 83), where
name
is the new image scanner name. Scan the Reset bar
code (page 1-8 or on the Programming Chart inside the back cover of this man-
ual). You may use Barcode Builder, which is included with Quick*View. You
may download Quick*View from the Honeywell International Inc. website: at
www.honeywellaidc.com.
0001
0002
0003
0005
0007
0004
0006
Reset
0002
Image Scanner Name