Filter
Top Products
2 - 11
RS-232 Handshaking
RS-232 handshaking is a set of rules concerning the exchange of data between
serially communicating devices.
Default = RTS/CTS, XON/XOFF and ACK/
NAK
Off
Wand Emulation Connection
The Wand Emulation Connection bar codes should be used if you want to
change the terminal ID
only
, without changing any other imager settings. We
recommend using Wand Emulation Plug & Play bar codes to program your
imager to emulate a wand reader. The Wand Emulation Plug & Play bar codes
change other parameters, in addition to changing the terminal ID. Please refer
to
Wand Emulation Plug & Play on page 1-7 for further information.
In Wand Emulation mode, the imager decodes the bar code then sends data in
the same format as a wand imager. The Code 39 Format converts all symbolo
-
gies to Code 39.
The Same Code Format transmits U.P.C., EAN, Code 128 and Interleaved 2 of
5 without any changes, but converts all other symbologies to Code 39. 2D sym
-
bologies are converted to Code 128.
The
Code 39 Format
bar code below sets the terminal ID to 61, and the
Same
Code Format
bar code sets the terminal ID to 64.
RTS/CTS On
* XON/OFF Off
* RTS/CTS Off
XON/XOFF On
ACK/NAK On
* ACK/NAK Off
Code 39 Format
Same Code Format