Filter
Top Products
14 www.honeywell.com
Installing the NetAXS-123 Panels
Installation
6. Connect the Ethernet cable and the Tamper wire, as shown below.
7. Set DIP switch settings for the panel address, communication termination and biasing. See DIP
Switch Settings, page 36.
8. Check all wiring at this time.
Caution: Improper wiring can cause damage to the NetAXS-123 at power up and result in a loss
of warranty.
9. Apply power to the panel.
10.Check for the Run LED for a successful power-up. If the LED is blinking green, the panel is
powered up successfully.
11.Close the cover.