Humminbird 531906-1EN_A Switch User Manual


 
Change the Sonar Source
To change the sonar source, open the Network Source Setup dialog box and
change the transducer source at any time (see Select a Sonar Source).
Network settings are saved even after the unit is powered off.
If the control head cannot detect the set transducer, an error message
displays so that you can reset the transducer source as follows:
If the shared transducer is not detected on the network, follow the
on-screen instructions to switch to the transducer connected to the
control head.
If the local transducer is not detected, follow the on-screen
instructions to switch to another transducer in the network. If there is
more than one transducer in the network, you can select a different
transducer from the Network Source Setup dialog box. See Select a
Sonar Source for details.
16
Sonar Sources