Filter
Top Products
Change the GPS Source
To change the GPS source after the network has been configured, open the
Network Source Setup dialog box to change the GPS sources at any time.
Network settings are saved even after the unit is powered off.
If the control head cannot detect the set GPS receiver, the control head will
display an error message so that you can reset the GPS source as follows:
• If the shared GPS receiver is not detected, follow the on-screen
instructions to switch to the GPS connected to the control head (Local).
• If the local GPS receiver is not detected, follow the on-screen
instructions to switch to another GPS receiver in the network. If there
is more than one GPS receiver in the network, the Network Source
Setup dialog box will display, and you can select a different GPS source.
See Select a GPS Source for details.
If the control head cannot detect the shared GPS Receiver set in the network, follow the
on-screen instructions to change the GPS source. In the above illustration, the control
head is switching to the locally-connected GPS receiver. Press the LEFT Cursor key to
select No, or press the RIGHT Cursor key to select Yes.
Finding the GPS Source
700 Series™
27
GPS Sources