Filter
Top Products
Changing Software Option Settings 4-7
7 When the next screen appears, select Configuration and
Diagnostic Program.
8 Highlight Install and press [Enter].
9 Press [Enter] to select Configure Adapter.
A screen similar to the one shown in Figure 4-3 appears.
Figure 4-3 Adapter Configuration Screen
10 Use the arrow keys to highlight a desired parameter option
and press [Enter].
A second dialog box appears.
11 Use the arrow keys to scroll through the list of settings for
that option. Select a setting and press [Enter].
12 Continue this procedure with any of the other options.
13 Press [Tab] three times to highlight <OK>. Press [Enter].
You must highlight <OK> and press [Enter] to save the new
settings to the adapter.
Diagnostic and Manual Configuration Program
InstallQuit View Select
Adapter Configuration
F1=Help
[ENTER]=Change the Setting
[
↑↓
]=Scroll
[Alt]+<Highlighted Key>=Execute Function
Test
CancelOKModify File Options
TokenLink III Adapter Configuration
3Com
A20h
3
16 Mbps
CC000h
D8000h - DBFFFh
16 bit
16 bit
Edge Triggered
Enabled
Enabled
Configuration Mode
l/O Base Address
Interrupt Request Level
Ring Speed
BIOS/MMIO Base Address
Shared RAM Address Range
Memory Mode
I/O Mode
IRQ Driver Type
Auto Switch
Boot PROM