Filter
Top Products
7-8 CHAPTER 7: TROUBLESHOOTING
Changing the Test Setup
If you want to change the test parameters, follow these steps:
1 Choose the <Test Setup> command button in the Run Tests
dialog box shown in Figure 7-4.
The Test Setup dialog box appears, as shown in Figure 7-5.
Figure 7-5 Test Setup Dialog Box
2 Press [Tab] to move from field to field and highlight any
field within the Test Setup dialog box.
Within the Group Select area, use the arrow keys to highlight
Group 1 or Group 2. Use the <Enable Group> or <Disable
Group> command buttons to enable or disable a group of tests.
For a description of these tests, refer to the on-line help in
the diagnostic program.
3 When you are satisfied with the new test setup, highlight
the <OK> command button and press [Enter].
4 To run the tests, choose Run Tests from the Test menu and
select the <Start> button.
Diagnostic and Manual Configuration Program
InstallQuit View Select
Test Setup
F1=Help
[
↑↓
]=Select a Test Group to View
[Alt]+<Highlighted Key>=Execute Function
[TAB]=Next Field [SHIFT+TAB]=Previous Field [F1]=Help [ESC]=<Cancel>
Test
Defaults
File Options... OK Cancel
Enable Group
Disable Group
Group 1
Group 2
Group Select
Repetitions
(.) [1 ]Times
Errors
[X] Halt on Error
*Enabled
*Enabled
*Enabled
*Enabled
*Enabled
*Enabled
*Enabled
*Enabled
Group 1 Tests
Continuous
MMIO Register Write/Read Test
AIP Checksum Test
Shared RAM Boundary/Domain Test
Shared RAM Write/Read Test
Timer Test
Open Adapter for Ring Operation Test
Ring Operations Test
Close Adapter Test