Filter
Top Products
3-6 CHAPTER 3: INSTALLING THE NETWORK DRIVER
If the adapter is not disabled and a red X still appears next to
the name of the adapter, update the driver by following
these steps:
a Double-click the name of the adapter.
b Select the Driver tab, and then click the Update Driver
button.
c Insert EtherDisk Diskette #2 when prompted for a disk.
Continue with the installation by following the prompts
on the screen.
If a yellow exclamation point (!) appears next to the name of
the adapter, the installation is not complete. See Appendix B
for troubleshooting help.
Upgrading from Windows 95 to Windows 98
If you are upgrading a PC from Windows 95 to Windows 98
that already has an EtherLink or Fast EtherLink XL (3C90xB)
adapter installed, you may have to update the driver in the
Device Manager using EtherDisk Diskette #2.
Follow the instructions in the previous section, “Verifying
Successful Installation Under Windows 98,” to determine
if you have to update the driver.
Windows NT
This section describes how to install the network driver in a
PC running Windows NT versions 4.0 or 3.51.
Do not use the AutoLink software to install the driver if you
are running Windows NT.
Before you begin, obtain EtherDisk Diskette #2 and
Windows NT installation files (on hard disk, diskettes,
or CD).