Filter
Top Products
Mouse
Note: A sticking keybutton can cause the mouse to operate incorrectly. If
you suspect this, go to “Keyboard” on page 2-39.
001
– Check the mouse connection and reseat the cable in the correct plug.
– Insert the Diagnostics and Utilities CD into the CD/DVD-ROM drive.
– Power-off the system unit.
– Make sure the mouse ball turns freely.
– Power-on the system unit.
– Make a note of any error messages, then press Esc.
– Select Advanced Diagnostics from the Main Menu.
– Select Interactive Test from the Main Menu.
– Select Mouse from the menu.
– Perform the mouse test.
DO THE MOUSE DIAGNOSTIC TESTS RUN WITHOUT ERRORS?
Yes No
002
– For Type 2140, replace the mouse. If symptoms remain, replace
the system board.
– For Type 2142, Power-off the system and connect the keyboard and
mouse to the system board. Run the mouse tests again. If
symptom remains, replace the mouse. If the mouse tests run
without errors while connected to the system board, replace the
Media Console client card. Reconnect the keyboard and mouse to
the Media Console
003
– The system unit is operating normally.
– If the symptom remains, replace the mouse.
2-42