Filter
Top Products
Diagnostic Aids 79
Power-On Self Test
Each time you power-on the system, the power-on
self test (POST) is initiated. Several items are tested
during POST, but is for the most part transparent to
the user.
POST checks the following:
To start POST, turn on the monitor and then the
system unit. The following will happen:
1. The IBM Personal Computer logo will appear on
the screen.
2. At this time one of two hot-keys may be used. The
F1 key will cause the system Configuration/Setup
Utility menu to appear. The F9 key will switch the
graphical IBM logo screen to the traditional text-
based system startup screen, which displays BIOS
version and system memory tested. For Personal
Computer Type 2274, the F9 key will only work
after exiting Configuration/Setup Utility.
3. If an error is detected during POST, the IBM logo
screen will automatically switch to the text-based
screen and display the error message or code with
a beep. Depending on the criticality of the POST
error, the system may halt and/or display the
message “Press
<F1>
to enter to the Setup or
<Enter>
to continue...”
If this message appears, pressing the
Enter
key
will allow the system to attempt to proceed despite
the reported error; pressing
F1
will cause the
system Configuration/Setup Utility menu to appear.
•
System Board
•
Mouse
•
Memory
•
Parallel Port(s)
•
SVGA Controller
•
Serial Port(s)
•
Hard Disk Drive(s)
•
CD/DVD-ROM Drive(s)
•
Floppy Diskette
Drive(s)
•
Sound Controller*
•
Keyboard