Filter
Top Products
viii
Safety Information
DANGER
To avoid a shock hazard, do not connect or
disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during
an electrical storm.
To avoid shock hazard:
•
The power cord must be connected to a properly
wired and earthed receptacle.
•
Any equipment to which this product will be
attached must also be connected to properly wired
receptacles.
When possible, use one hand to connect or
disconnect signal cables to prevent a possible shock
from touching two surfaces with different electrical
potentials.
Electrical current from power, telephone, and
communications cables is hazardous. To avoid shock
hazard, connect and disconnect cables as described
following when installing, moving, or opening covers
of this product or attached devices.
IMPORTANT:
When replacing the battery, use only IBM Part
Number 33F8354 or an equivalent type battery
recommended by the manufacturer. If your
system has a module containing a lithium
battery, replace it only with the same module
type made by the same manufacturer. The
To Connect
1. Turn Everything OFF.
2. First, attach all cables to
devices.
3. Attach signal cables to
receptacles.
4. Attach power cord(s) to
outlet.
5. Turn device ON
To Disconnect
1. Turn Everything OFF.
2. First, remove power
cord(s) from outlet.
3. Remove signal cables
from receptacles.
4. Remove all cables from
devices.