Filter
Top Products
Check Procedures 43
Floppy Disk(s) Fail (80) 1. Re-connect floppy disk
drive
2. Enter Configuration/
Setup Utility and load the
default settings.
3. Floppy disk drive
4. System board
Floppy Disk(s) Fail (40) 1. Re-connect floppy disk
drive
2. Enter Configuration/
Setup Utility and load the
default settings.
3. Floppy disk drive
Hard Disk(s) Fail (80)
Hard Disk(s) Fail (40)
1. Enter Configuration/
Setup Utility and load the
default setting
2. Check IDE drive jumper.
See “3.5-In. Hard Disk
Drive Jumper Settings”
on page 117.
3. IDE hard disk drive
power.
4. IDE hard disk drive cable/
connection.
5. IDE hard disk drive.
6. System board
Hard Disk(s) Fail (20)
Hard Disk(s) Fail (10)
1. Enter Configuration/
Setup Utility and load the
default setting
2. IDE hard disk drive
power.
3. IDE hard disk drive cable/
connection.
4. IDE hard disk drive.
Hard Disk(s) Fail (08) 1. Hard disk drive
Table 2-1 POST Error Codes and Messages List
NOTE:
To diagnose a problem, first find the BIOS error
messages or codes in left column. If directed to a
check procedure, replace the FRU indicated in the
check procedure. If no check procedure is indicated,
the first Action/FRU listed in right column is the most
likely cause.
BIOS Error Codes,
Messages
Action/FRU