Filter
Top Products
If the Add New Hardware Wizard window does not open in step 1 of the
previous procedure, check the Device Manager list to see if the new adapter is
present. If it is not, follow these instructions to manually add the adapter:
Manually adding the Ethernet adapter device drivers with Windows 95:
1. Click Start -> Settings -> Control Panel.
2. From the Control Panel, double-click the System icon.
3. Click the Device Manager tab.
4. Double-click Other Drives (question mark icon) in the list area.
5. Double-click PCI Ethernet Controller.
6. Click the Driver tab, and then click Update Driver.
7. Insert the IBM Data Migration User’s Guide and Software CD into the
CD-ROM drive, if it is not already inserted. If the CD browser window
opens after you insert the CD, close that window.
8. At the Update Device Driver wizard, click No and click Next.
9. Click Have Disk.
10. In the Select Device window, type e:\Drivers\Intel\w9x where e
represents the drive letter of the CD-ROM drive. Click OK.
11. Follow the instructions to install the device drivers. When the adapter is
added, it is shown in the Network adapters list.
12. Follow any prompts for Windows 95 Installation disks and restart when
prompted.
13. Proceed to “Connecting the computers” on page 1-11.
Installing the Ethernet adapter in a mobile computer (PC
Card Kit)
If your previous computer is a mobile computer without an Ethernet adapter,
follow this procedure to install the Ethernet PC Card adapter that comes with
the PC Card Kit.
1. Connect the converter cable to the Ethernet PC card adapter as shown in
the following illustration.
2. Turn on your computer if it is not already on, and wait for Windows to
start.
Installation and user’s guide 1-9