Filter
Top Products
5. Set Automatic Hardware Power Management to Enabled.
6. Select values for the three categories of power management (system
power, processor speed, and display), as necessary.
7. Set Hard Disk to Enabled or Disabled.
Note: This does not apply to SCSI drives.
8. Press Esc twice to return to the Configuration/Setup Utility program
menu.
9. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
10. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
Automatic Power-On features
The Automatic Power-On features within the Power Management menu allow
you to enable and disable features that turn on the computer automatically.
v Serial Port A Ring Detect: With this feature set to Enabled and an external
modem connected to serial port (COM1), the computer will turn on
automatically when a ring is detected on the modem.
v PCI Modem Ring Detect: With this feature set to Enabled , the computer
will turn on automatically when a ring is detected on the internal modem.
v PCI Wake Up: This feature allow PCI cards that support this capability to
wake the system.
v Wake Up on Alarm: You can specify a date and time at which the
computer will be turned on automatically. This can be either a single event
or a daily event.
v Wake on LAN: If the computer has a properly configured token-ring or
Ethernet LAN adapter card that is Wake on LAN-enabled and there is
remote network management software, you can use the IBM-developed
Wake on LAN feature. When you set Wake on LAN to Enabled, the
computer will turn on when it receives a specific signal from another
computer on the local area network (LAN). For further information, see
“Wake on LAN” on page 54.
Network settings
This section applies only to computers that are linked to a network.
The Configuration/Setup Utility program includes settings that can be
enabled and disabled to configure the network interface in the computer.
These settings are the following:
v Flash over LAN (Update POST/BIOS over Network)
v Wake on LAN
Chapter 2. Types 6568/6569/6648/6649 53