Filter
Top Products
Diskette Drive Assembly
Removal
1. If you have not already done so, remove the cover as described in “Removing
the Cover” on page 7-3.
2. Disconnect the following cables from the drive:
Signal cable
Power cable
3. Remove the media front cover, as described in “Front Covers” on page 7-17.
4. Pull out both locking knobs (A), as shown in the following illustration.
A
5. Pull out the drive assembly.
6. Remove the screws that hold the drive to the tray.
7. Lift the drive out of the tray.
Replacement
Replace in the reverse order.
7-22 7046 Model B50 Service Guide