Filter
Top Products
Chapter 4. Installing, Migrating to, and Deleting MQSeries
for AS/400
This chapter describes installation of and migration to MQSeries for AS/400,
V5.1. It covers the following topics:
v “Before Installation”
v “Installation Procedure” on page 21
v “Verifying the Installation” on page 22
v “Quiescing MQSeries” on page 23
v “Migrating to MQSeries for AS/400, V5.1” on page 24
v “Verifying the Migration” on page 29
v “Deleting MQSeries for AS/400, V5.1” on page 31
In addition to reading the information in this chapter, you should refer to the
readme file on the publications CD-ROM, and also to the latest information
available on the MQSeries Web site at:
http://www.ibm.com/software/ts/mqseries/
Before Installation
If you are migrating from an earlier release of MQSeries for AS/400, refer to
“Migrating to MQSeries for AS/400, V5.1” on page 24.
You must have the OS/400 V4R4 operating system installed on your machine
in order to run MQSeries for AS/400, V5.1. If you have OS/400 V4R2 or V4R3
operating system installed, you can use only MQSeries for AS/400 V4R2M1.
Setting System Values
Before installing MQSeries for AS/400, you should use the DSPSYSVAL
command to check that the following system values are set to the
requirements of your enterprise:
v QCCSID
v QUTCOFFSET
v QSYSLIBL
v QALWOBJRST
You can change these values, if necessary, using the CHGSYSVAL command.
© Copyright IBM Corp. 2000 19