Filter
Top Products
/G:include path
Specifies the drive and path of a general response file to be included by
the specific response file. For more information about response files, see
“Installation Response Files” on page 73.
/L1:error log
Specifies the drive, path, and file name of the error log file. The error log
contains messages associated with installation, including confirmations
and error messages. Messages are written to the error log if you specify
the /X parameter.
You should specify the drive and path where the installation program is
running. If you do not specify the /L1 parameter, no error log is
maintained. If the error log already exists, it is appended to.
Example:
/L1:D:\LOG\INSMQM.OUT
/L2:history log
Specifies the drive, path, and file name of the history log file. The history
log contains an entry for each file transferred, each object created, and
each installation exit run.
You should specify the drive and path where the install program is
running. If you do not specify the /L2 parameter, no history log is
maintained. If the history log already exists, it is appended to.
Example:
/L2:D:\LOG\INSMQM.HIS
/R:response file
Specifies the drive, path, and file name of a response file; see “Installation
Response Files” on page 73.
Example:
/R:L:\MQMINS\AMQISAM2.RSP
/S:source location
Specifies the drive and path containing the source files to be installed or
updated.
/T:install target directory
Specifies the drive and path that MQSeries for OS/2 Warp files are
installed on to. If you specify this parameter, it overrides the FILE path,
which must be specified in the response files.
/TU:update CONFIG.SYS directory
Specifies the drive and path of the target CONFIG.SYS to be updated.
/X Specifies that the installation is fully automatic.
Installing on OS/2 Warp
72
MQSeries for AS/400, V5.1 Quick Beginnings