Filter
Top Products
User Exits
Before using user exits on MQSeries for AS/400, V5.1, relink them with the
threaded libraries and ensure that they are thread-safe and teraspace enabled.
See the MQSeries Application Programming Guide and the MQSeries
Intercommunication book for further information about creating user exit
programs.
Setting the Queue Manager CCSID for MQSeries for AS/400
When you create a queue manager, its coded character set identifier (CCSID)
is set by default. It is set to the value of the CCSID of the OS/400 job you
used to create the queue manager.
You can query the value of this CCSID by entering the DSPMQM CL
command. This displays the attributes of the local queue manager, including
the coded character set identifier.
You can modify the queue manager’s CCSID by using the CHGMQM CL
command. Before doing this, make a note of the original CCSID value in case
you need to reset it at a later date. To change the CCSID, follow this
procedure:
1. Issue the DSPMQM command and make a note of the CCSID value.
2. Change the CCSID to the new CCSID, with the command:
CHGMQM CCSID(value)
3. Stop the queue manager with the ENDMQM command.
4. Restart the queue manager with the STRMQM command and also restart
any channels that it uses.
For information about code sets and CCSIDs that are supported by MQSeries
for AS/400 see the AS/400 National Language Support book. See the MQSeries
Command Reference for more information about MQSeries commands.
User Exits
Chapter 5. Using MQSeries for AS/400, V5.1 43