Filter
Top Products
CHAPTER 2 CONFIGURATION
User's Manual U13502EJ2V0UM00
25
Photo 2-6. Connecting Target Cable to User Target
For the details of interface signal connections, see
Section 7.4
and the manual for the device.
•
When using the FA adapter
Make sure that the target V
DD
select switch is set to the OUT position. Connect one end of the Type 2 cable to
the PG-FP3, and the other end of the cable to the mating connector of the FA adapter. Alternatively, directly
connect the D-SUB connector of the FA adapter to the target interface connector of the PG-FP3.
The FA adapter has a D-SUB connector and a connector supporting the Type 2 cable. Connect the FA adapter
in either of the ways described above. For the wiring of the FA adapter, refer to the FA adapter manual or the
manual for the device.
Photo 2-7. Connecting Target Cable to PG-FP3 <2>