Filter
Top Products
CHAPTER 7 HARDWARE SPECIFICATIONS
User's Manual U13502EJ2V0UM00
83
[Cable specifications]
Two types of target interface cables (IC clip type (TYPE 1) and connector type (TYPE 2)) are supplied. Use the
appropriate cable for the situation.
If the supplied cables cannot be used because of the specifications of the target and the user prepares a cable,
keep the cable length to within 40 cm and use materials with frequency characteristics equivalent to those of the
supplied cables.
Note, however, that an error may occur during communication and operation may not be performed correctly if a
cable other than those supplied is used because communication rate is too high for the communication setting.
The following are the specifications for each cable.
Item Specification Connection Remarks
TYPE 1 PG-FP3 side connector:
D-SUB 9-pin (plug)
Standard: FDE-9P (05)
Manufacturer: Hirose
Target side connector:
IC clip (9 pcs)
D-SUB IC clip
Plug 9-pin (9 pcs)
1 --- GND (black)
2 --- SI (yellow)
3 --- SO (blue)
4 --- SCK (white)
5 --- CLK (green)
6 --- _RESET (green)
7 --- V
DD
(red)
8 --- V
PP
(green)
9 --- HS (green)
TYPE 2 PG-FP3 side connector:
D-SUB 9-pin (plug)
Standard: FDE-9P (05)
Manufacturer: Hirose
Target side connector:
FAS connector
10-pin (receptacle)
Standard: FAS-1001-2101
Manufacturer:
Yamaichi Electric
D-SUB FAS connector
Plug 9-pin Receptacle 10-pin
1 --- 1
2 --- 2
3 --- 3
4 --- 4
5 --- 5
6 --- 6
7 --- 7
8 --- 8
9 --- 9
10 (Open)
6
7
8
9
10
1
2
3
4
5
(When viewed from socket)
mark
Pin configuration of FAS
connector