Filter
Top Products
CHAPTER 8 ERROR MESSAGES AND REMEDIAL ACTIONS
User's Manual U13502EJ2V0UM00
89
Error No. Message Cause/action
Cause The data stored in flash memory cannot be read.ER24 Cannot get TYPE data.
Action The internal flash memory in the PG-FP3 may have been
destroyed.
Cause An overrun error was detected during communication with the host
machine.
ER26 Over run error.
Action Check the connection environment with the host machine.
Cause A framing error was detected during communication with the host
machine.
ER27 Framing error.
Action Check the connection environment with the host machine.
Cause A parity error was detected during communication with the host
machine.
ER28 Parity error.
Action Check the connection environment with the host machine.
Cause The block set with TYPE setting does not exist.ER30 Illegal select BLOCK !
Action Check the block information in the TYPE settings.
Cause The E.P.V. command was executed in the BLOCK mode.ER31 EPV is not supported BLOCK
operation
Action The version of the PG-FP3 terminal software does not match.
Cause An attempt was made to perform batch processing with a device
with ECC memory.
ER32 Cannot execute when ECC set.
Action Batch processing cannot be performed with a device with ECC
memory.
Cause An ECC memory address was not entered.ER33 ECC BLOCK address unknown.
Action An ECC memory address was not entered correctly.
Cause A value exceeding the range was specified.ER34 Unpacked BCD format error.
Action The version of the PG-FP3 terminal software does not match.
Cause IIC communication errorER35 Cannot get SLAVE address.
(1 bit)
Action Check the wiring and other devices on IIC.
Cause IIC communication errorER36 Cannot get SLAVE address.
(9 bit)
Action Check the wiring and other devices on IIC.
Cause IIC communication errorER37 Cannot get SLAVE address.
(ACK)
Action Check the target microcontroller.
Cause IIC communication errorER38 IIC WRITE error. (1 bit)
Action Check the wiring and other devices on IIC.
Cause IIC communication errorER39 IIC WRITE error. (9 bit)
Action Check the wiring and other devices on IIC.
Cause IIC communication errorER3A IIC WRITE error. (ACK)
Action Check the target microcontroller.
Cause IIC communication errorER3B IIC READ error. (1 bit)
Action Check the wiring and other devices on IIC.
Cause IIC communication errorER3C IIC READ error. (9 bit)
Action Check the wiring and other devices on IIC.