Filter
Top Products
LitePro 760 User’s Guide 5
Connecting the LitePro 760
This chapter describes how to position the LitePro for optimum
viewing and how to connect it to your computer.
Setting Up
1.
Place the projector on a flat surface.
• The projector must be within 6 feet of your power source.
• The projector must be within 6 feet of the computer.
• If you are installing the projector on the ceiling, refer to the
Ceiling Mount Installation Guide
for recommendations. (The
Ceiling Mount Kit is sold separately.)
• For information about projector placement and image size, see
the “LitePro Tips” box on the next page.
2.
Orient the projector so that its lens faces the projection screen.
• If you want to use the LitePro’s Rear Project feature, set it up
behind your translucent screen. Refer to “Rear Projection” on
page 23 for more information.
3.
If the projection lamps have not been installed in the projector
yet, refer to “Replacing the Projection Lamps” on page 28 for
installation instructions.
4.
Remove the lens cover.
5.
Plug the power cord into the projector, then plug it into your elec-
trical outlet.
• While the cord is connected, you can switch the projection
lamp off by pressing the
standby
button on the remote. The
lamp turns off to conserve electricity.
Always use the power cord that was shipped with your LitePro 760.
The projector accepts power from 100 VAC and 220 VAC, 50 or 60
Hz, three-wire type grounded sources. When you disconnect the
projector, always remove the power cord from the electrical outlet
first, then from the projector.
Osprey.bk Page 5 Monday, December 11, 2000 1:38 PM